Changing the string on your weed wacker is easy. This article covers changing the string on Homelite weed wackers and trimmers with two-hole heads. Follow these simple steps and you’ll be up and running in no time. If you’re having trouble getting the right amount of string, you can easily reload the tool by following the instructions below. You should have a fresh string in your weed wacker every few weeks to ensure a clean, efficient cut.
Changing the string on a weed wacker
One of the most important pieces of lawn equipment is a weed wacker, which can be used to cut grass and trim weeds in hard-to-reach areas. A weed eater is easily changed out for a new one to maintain its performance. Weed eaters have different spool heads and the length of the string varies from model to model. To change the string, first un-screw the spool head. Then, push the tabs inward and release the spool. You may need to watch for the nuts as you remove the spool. After releasing the spool, cut a new string for around 15 to 25 feet.
You can buy weed eater strings at almost any hardware store. The spool has an arrow that shows you how to wind the string. You should wind the new string from one side to the other. It’s best to overlap the new string, as this will keep it from tangling. In addition, if your weed eater has two strings, make sure you wind the second piece of string from the opposite side of the spool.
A string trimmer with two holes is also called a dual-sided trimmer. You can change the string on a dual-sided trimmer by inserting two different pieces of line into the head. Most heads are designed to accommodate one string or two, but some can hold two pieces of string. You should make sure you change the string after the previous one has reached its maximum length, as overfeeding the string will make the string last less than its desired lifespan.
Changing the string on a Homelite weed whacker
Changing the string on a Homelite gas-powered weed eater is a relatively easy process. The weed eater is a lightweight gas-powered string trimmer that can cut long weeds and perform general yard maintenance. The string spool accepts two lengths of 0.080 microfilament line and advances when the string head is tapped against the ground. You can either buy a new pre-strung spool or rewind the existing one to get a new string. Always disconnect the spark plug wire as a safety measure.
Changing the string on a Homelite string trimmer is a standard procedure for most weed whackers. It’s a good idea to check the product manual to see what size string is necessary for your specific machine. If the line is too wide or thick, you may end up with a weed cutter that can’t reach the area. To find the correct size, look in the instruction manual or on the Internet.
Changing the string on a weed wacker with a two-hole trimmer head
Changing the string on a weed eater with a two-hole trimmer head can be done by following a few simple steps. First, unplug the string trimmer before you begin. It will vary from model to model, so make sure to read your owner’s manual before starting. Then, place the spool of new string inside the trimmer’s head, winding it in the direction shown by the arrow.
After you have unplugged your weed wacker, unscrew the spool and pull out the old string. Many models will have a specific size for the new string, so be sure to look closely to make sure you match the new string with the previous one. To replace the string, measure and cut a new string that is about 15 to 25 feet long.
To change the string on a weed wacker, follow the instructions below. First, remove the old string from the weed wacker’s spool. You may need to loosen the spool, but it will work. Afterward, reinstall the head cover. Make sure to remove the old string before using the weed wacker.